ABB SCK - Page 160

160 Operating instruction SCK Gas Sampling System OI/SCK-EN Rev. E
Risk of scalding due to hot cooling water when working on the cooling-
water circuit, above all on drain valves and screw connections
 Do not perform work on the cooling water circuit until the gas sampling
system has cooled down.
Danger of injury to skin and eyes in the event of contact with cooling water
or anti-freeze
 Avoid contact with the cooling water and the anti-freeze.
 Wash any cooling water and anti-freeze off the skin immediately with
water and soap.
 If cooling water or anti-freeze gets in the eyes despite protective glass-
es, rinse them thoroughly under running water, holding the eyelids open.
 Observe instructions in the anti-freeze manufacturer's safety data sheet.
Danger due to skin and eye injuries in the event of contact with lubricating
oil from the pneumatic box of, from the filter muffler or from inside the
pneumatic motor
 Avoid contact with lubricating oil.
 Wash any lubricating oil off the skin immediately with water and soap.
 If any lubricating oil gets in the eyes despite protective glasses, rinse
them thoroughly under running water, holding the eyelids open.
 Observe instructions in the lubricating oil manufacturer's safety data
sheet.
Danger due to harmful dusts when cleaning the gas sampling system
 Wear a dust mask when cleaning.
 Wash any dust off the skin immediately with water and soap.
Risk of falling on slippery floor due to escaped or spilled cooling water and
lubricating oil or dirt
 Always keep the floor around the gas sampling system clean and dry.
Hot cooling water
Harmful
anti-freeze
Harmful
lubricating oil
Harmful
dusts
Slippery floor