172 Operating instruction SCK Gas Sampling System OI/SCK-EN Rev. E
Perform the following steps to check the additional warning horn (provided
by customer):
Switch system to manual mode on the touchscreen (if this has
not already been done).
Path: Operation ► Automatic on / off
Retract gas sampling probe out of the kiln.
Path: Operation ► Probe ► Probe Action ► Retract
Target requirement:
The warning horn goes off.
In the event of irregularities, shut down the sampling system,
secure against start-up (e.g. with a padlock), and have it re-
paired by trained, expert personnel.
If they are working as intended:
Turn service switch back to
OFF
position and insert gas sam-
pling probe again using the controller.
WARNING! Gas sampling probe moves into the kiln. Do not
stand in the area of travel of the gas sampling probe or probe
carriage until the probe is completely inserted into the kiln
and the warning lamps go out.
checking the
additional warning
horn
To Next Page
Loading...
