ABB SCK - Page 194

194 Operating instruction SCK Gas Sampling System OI/SCK-EN Rev. E
Perform the following steps to check the filter muffler on the compressed-air
motor ( -J83 ):
Step
Procedure
1
Pull the drip cup (1) off the filter muffler -J83 .
2
Unscrew filter element.
3
Inspect and, if necessary, replace filter element.
4
Screw filter element back on.
5
Put the drip cup back on.
6
Unlock EMERGENCY STOP switch, turn service switch back to
OFF position and insert probe again using the controller.
WARNING! Probe moves into the kiln. Do not stand in the area
of travel of the probe or probe carriage until the probe is
completely inserted into the kiln and the warning lamps go
out.
Instructions