101 SOUND PARAMETERS REFERENCE
Spread
Available if both filter SELECT buttons are active. Accessible
from the panel via the ENV AMOUNT knob.
> -64 to +63: Simultaneously controls Carrier Spread and Mod-
ulator Spread (see below).
Q-Factor
Only available if both filter SELECT buttons are active. Accessi-
ble from the panel via the RESONANCE knob.
> -64 to +63: Simultaneously controls Carrier Q and Mod Q
(see below), overriding those two parameters.
Mode
See “Mode” on the previous page.
Carrier Spread
Accessible via the ENV AMOUNT knob when only FILT1 is
selected.
> -64 to +63: How far apart individual Carrier bands are. The
standard value is +63 (100% i.e. full range), negative values
effectively invert the order of bands – great for special effects.
Modulation destination “Filter1 Key Follow“.
Carrier Q
Accessible via the RESONANCE knob when FILT1 is selected.
> 0 to 127: Quality (steepness) of the Carrier bands. Modulation
destination “Filter1 Resonance“.
Mode
See “Mode” on the previous page.
To Next Page
Loading...
