How to resolve function abnormalities on Acer Projector?
If your Acer Projector is experiencing function abnormalities, first perform a 'Reset(All data)' of the OSD Menu. If the issue continues, check the Main Board and DMD Board.
How to fix mechanical noise on Acer P7280 Refresh?
If you are experiencing mechanical noise with your Acer Projector, check the Color Wheel and Fan Module.
How to fix audio abnormalities on Acer Projector?
If you are experiencing abnormal audio on your Acer Projector, ensure that the signal cables and source are working correctly. If the issue persists, check the Speaker Module and Main Board.
What causes line bars or line defects on Acer P7280 Refresh Projector?
To address line bars or line defects on your Acer Projector, check if the Main Board and DMD Board are assembled properly. If they are, check the Main Board, DMD Board, and DMD Chip.
How to fix dead pixel or dust issues on Acer P7280 Refresh Projector?
To address dead pixels or dust issues (out of specification) on your Acer Projector, ensure the projection screen is free of dirt and the projection lens is clean. If the problem persists, clean the DMD Chip and Engine Module. Also check the DMD Chip and Engine Module.
Details projector specifications including dimensions, weight, cooling system, and power supply.
Lists supported resolutions and signal timings for VGA and DVI analog/digital inputs.
Visual overview of the projector's front and upper side components with itemized descriptions.
Table mapping LED status indicators to specific error messages and their corresponding meanings.
General troubleshooting steps for common symptoms like no power or auto shut down.
Describes beep patterns and their corresponding error conditions or functions.
Lists necessary hardware and software for testing and alignment procedures.
Instructions on how to access and exit the projector's service mode.
Specifies environmental conditions and run-in times required for testing.
Details procedures for frequency, tracking, light leak, blemish, and focus tests.
Procedures for measuring brightness, contrast, and uniformity of the projected image.
Lists required software (DLP Composer) and hardware for firmware updates.
Step-by-step guide to perform firmware updates using DLP Composer.
Procedure for downloading waveform data, typically after hardware changes.
Explains Extended Display Identification Data (EDID) and its role in display communication.
Detailed steps for inputting EDID data via a program and specific ports.
Procedure to reset the default language setting after EDID upgrade or other changes.
Contains detailed exploded view diagrams of projector assemblies with part numbers.
Explains the format and meaning of serial number components for non-refresh models.
Explains the format and meaning of serial number components for refresh models.
Defines the structure and meaning of PCBA codes used for identification.
Lists RS232 commands and their corresponding function features for projector control.
To Next Page
General
