ActronAir ELY620T - Page 90

90
Installation and Commissioning Guide 500-700 Tri-Capacity Split Ducted
Doc. No.0525-098 Ver. 2 210330
Installation and Commissioning Guide
Split Tri-Capacity
G. Service e. Communicate config.
Ge1
Address: Protocol:
MODBUS CAREL MODBUS EXT.
Speed:
19200 9600 4800 2400 1200
Ge2
Enable the BMS to turn the unit On / Off:
No Yes
On loss of Comms:
Turn Off Turn On Use timeclock
Ge3
Enable DIN4 to turn the unit On / Off
No Yes
G. Service f. Service settings a. Working hour set
Gfa1
Indoor Filter: hours
Filter Fault relay:
Yes
No
Indoor Fan: hours
Compressor: hours
G. Service f. Service settings b. Probe Adjustment
G1
(Return Air Temperature) Room Temp cal : °C
Gfc1
Room Temperature Setpoint:
o
C
Dead band:
o
C
Cool Proportion band:
o
C
Heat Proportion band:
o
C
Integral Time: second
Gfc2
Room Temperature use INDOOR sensor
After Hours :
SW and Temp. SW Only
Probe weight value :
Room Temp.:
o
C
Wall Cont Temp.:
o
C
Control Value:
o
C
Gfc4
Supply Fan
Minimum speed: %
Medium speed: %
Maximum speed: %
Supply Fan Temp.
Minimum temp.:
o
C
Maximum temp.:
o
C
Gfc5
Supply Fan Gen. 3:
No Yes
Supply Fan Continuous:
No Yes
Cycle on de-ice:
No Yes
One Speed Fan:
No Yes
Speed Fan:
Low Med High
Supply Fan Run-on: second
Heat Start Delay: second
Gfc6
Setpoint Limit Min. by user:
o
C
Setpoint Limit Max. by user:
o
C
User Setpoint:
User Mode Sel:
Modelock timer: second
Gfc7
Enable Night Mode by Scheduler:
No Yes
Start Time:
Finish Time:
Max Cond fan Spd: %
cct 2 max Spd: %
Gfc8
Multi Input 1
No Yes
SUPPLY AIR TEMP Probe Type
ECONOMY ENABLE NTC
NIGHT MODE ENABLE 0-5V
0-10V STAGE CONT
ON/OFF
0-10V IN FAN SPD 4-20mA
VIEW ONLY INPUT
0-20mA
CO
2
SENSOR 0-10V
PHASE FAIL RELAY
Multi Input 2
No Yes
SUPPLY AIR TEMP Probe Type
ECONOMY ENABLE NTC
NIGHT MODE ENABLE 0-5V
0-10V STAGE CONT ON/OFF
0-10V IN FAN SPD 4-20mA
VIEW ONLY INPUT 0-20mA
CO
2
SENSOR 0-10V
PHASE FAIL RELAY
G. Service f. Service settings c. Thermoregulation
SYSTEM CONFIGURATIONS (To access this menu, please enter the Service password: 7378).