Adtech ADTECH4 CNC Series User Manual

ADTECH4 SeriesCNC Maintenance Manual
Note
:
The ID number setting of the controller when DNC or other PC software
and this controller are in MODBUS communication mode
014
Arc interpolation feed rate
Range
:
0~1
Unit
:
mm
Authority
:
Operation admin
Default
:
0.2
Effective time
:
Instant
Note
:
Set the arc interpolation equivalent
If this value is too small, the arc has higher approximation accuracy, but
the computation will be too high, making the pause during processing
obvious and affecting the processing effect.
015
G73(M) circulating tool retraction amount
016
G83(M) circulating tool retraction amount
Range
:
0.1~100
Unit
:
mm
Authority
:
Operation admin
Default
:
2.000
Effective time
:
Instant
Note
:
Set the tool retracting amount after Q is fed in G73 and G83 instructions;
this parameter (default: 2mm) is set according to actual chip removal
effect.
017
Arc interpolation processing mode
Range
:
Time split, position split
Unit
:
None
Authority
:
Operation admin
Default
:
Position split
Effective time
:
Instant
Note
:
Set the split mode of arc interpolation to position split or time split.
018
Speed optimization constraint mode
Range
:
Angle Speed Speed1
Unit
:
None
Authority
:
Operation admin

Adtech ADTECH4 CNC Series Specifications

General

Brand	Adtech
Model	ADTECH4 CNC Series
Category	Control Systems
Language	English