Adtech ADTECH4 CNC Series - Page 118

ADTECH4 SeriesCNC Maintenance Manual
Note
:
This parameter is invalid currently
060
4 -axis maximum speed
Range
:
1 ~ 500
Unit
:
Authority
:
Operation admin
Default
:
50
Effective time
:
Instant
Note
:
When P1.018 is set to (Angle X Y Z space angle optimization), set the
maximum rotation speed when the fourth axis A is the rotation axis.
061
Hand wheel encoder direction
Range
:
0~1
Unit
:
None
Authority
:
Operation admin
Default
:
0
Effective time
:
Instant
Note
:
When the logic direction obtained by handheld box encoder is reverse to
the actual motion direction of the axis, set this parameter to perform
in-phase setting.
0: positive direction
1: negative direction
062
Hand wheel control mode
Range
:
0 ~ 1
Unit
:
Authority
:
Operation admin
Default
:
0
Effective time
:
Instant
Note
:
Used to set hand wheel to control the motion of each axis; 0: old, 1: new
063
Hand wheel maximum rate
Range
:
500 ~ 10000