dynamic IP address, check the Use DHCP checkbox. If you do this,
then none of the other settings on the LAN Setup screen will be used.
To use a static IP address, uncheck the Use DHCP checkbox and enter
the additional information shown on the LAN Setup screen (your IT
department can tell you what you should enter).
When you are done, press the Apply Changes button.
Setting Up the
A
2
O ’s LIS Connection
Use the LIS Setup screen on the A
2
O to configure the A
2
O to communi-
cate with your LIS. To bring up the LIS Setup screen:
1. Starting at the main screen, press Menu, then press System
Configuration, and then press Supervisor Mode.
2. Press the Enter key.
3. If you are asked for a password, then type in the word password
and press the Enter key.
4. Press the LIS button.
The LIS setup only needs to be performed once.
117
Supplemental Laboratory Information System
To Next Page
Loading...
Need help?
General
