The OsmoPRO
®
Micro-Osmometer Service Manual
U.S. Safety This product has been listed by
ETL testing laboratories as being in
compliance with the requirements
of UL 61010-1, "Electrical
Equipment for Laboratory Use;
Part 1: General Requirements".
The "US" in the lower right of the
ETL mark demonstrates this listing.
Canadian Safety This product was listed by ETL
testing laboratories as being in
compliance with the requirements
of CAN/CSA C22.2 No. 61010-1,
"Safety Requirements for Electrical
Equipment for Measurement,
Control and Laboratory Use:
General Requirements". The "C" in
the lower left of the ETL mark
demonstrates this listing.
EC Declaration of This product meets the intent of
Conformity - EMC Directive
2014/30/EU
for
Electromagnetic Compatibility,
Class B. Compliance was demon-
strated using the following stan-
dards, as listed in the Official
Journal of the European
Communities: Consult the
Declaration of Conformance cer-
tificate shipped with the product
for the latest update.
• EN 61326-1, "Electrical
Equipment for Measurement,
Control, and Laboratory Use, Part
I, General Requirements".
EN 61326-2-6, “Electrical
Equipment for Measurement,
Control, and Laboratory Use, Part
2-6, Particular Requirements
IVD”.
EC Declaration of This product meets the intent
Conformity - IVD of Directive 98/79/EC for In Vitro
Diagnostic Medical Devices.
Consult the Declaration of
Conformance certificate shipped
with the product (if required) for
the latest update.
Regulatory
approval type Description
dential installation. This equipment gener-
ates, uses, and can radiate radio frequency
energy; if it is not installed and/or used in
accordance with the instructions, it may
cause harmful interference to radio com-
munications. However, there is no guar-
antee that interference will not occur in a
particular installation. If this equipment
does cause harmful interference to radio or
television reception, which can be deter-
mined by turning the equipment off and
on, the user is encouraged to try to correct
the interference by one or more of the fol-
lowing measures:
- Re-orient or relocate the receiving
antenna.
- Increase the separation between the
equipment and receiver.
- Plug the equipment into an outlet on a
different circuit from the one to which
the receiver is connected.
- Consult the dealer or an experienced
radio TV technician for help.
15
To Next Page
Loading...
Need help?
General
