23. Secure the Cable Clamp to the side of the
Power Supply & Controls Assembly
using the hex nut.
24. Plug the following Connectors into the
Control PCB: C1, C2, C5, C6, C10, &
C11.
25. Attach the C3G Ring Terminal to the side
of the Power Supply & Controls
Assembly using a screw. Plug the C3
Connector into the Control PCB.
26. Couple the following Connectors on the
Cooling System Harness with their mat-
ing Connectors: A1, A2, A3 & A4.
27. Secure the C10 Sample Probe Cable and
the C11 Block Probe Cable to the side of
the Power Supply & Controls Assembly
using a Cable Clamp and a screw.
28. Reverse steps one through four of the
General Disassembly Instructions to re-
assemble the instrument.
707011RPM Rev0
(OsmoPRO Service Manual)
Page 4 of 4
To Next Page
Loading...
