EasyManuals Logo

Advanced Instruments OsmoPRO Service Manual

Advanced Instruments OsmoPRO
139 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #30 background image
30
The OsmoPRO
®
Micro-Osmometer Service Manual
While the update is installing the sys-
tem will display the update progress.
Do not press or touch the screen of
the instrument until the installation is
complete.
(Please note that the Firmware revisions
displayed above may differ from your actual
display)
13. Upon completion the message shown
below will be displayed. Press OK.
14. Remove the USB thumb drive from
the OsmoPRO.
15. Press EXIT.
16. Power the instrument OFF.
8. After entering the correct password,
the SERVICE screen will display.
Insert the USB which contains the
OsmoPRO update files into the USB
port located on the front of the
OsmoPRO (underneath the
OsmoPRO logo).
9. Press the Control Board button.
10. Press the START button.
11. Press Ye s , and the update process
will start.
12. Wait for the update to complete
(approximately two minutes).
While the update is installing DO
NOT REMOVE THE USB FROM
THE OSMOPRO.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Advanced Instruments OsmoPRO and is the answer not in the manual?

Advanced Instruments OsmoPRO Specifications

General IconGeneral
BrandAdvanced Instruments
ModelOsmoPRO
CategoryMeasuring Instruments
LanguageEnglish

Related product manuals