www.advancedco.com
70
+ - + -
ZON E 1 ZON E 2
+ - + -
ZON E 1 ZO NE 2
+ - + -
ZON E 1 ZON E 2
+ - + -
ZON E 1 ZONE 2
CLASS B ZONE MONITOR
ALL CIRCUITS A RE POWER LIMITED
ON
1
ON = PBUS MODULE
ON = CLASS A / OFF = CLASS B
ON = EARTH MONITOR ACTIVE
ADDRES S
SETUP
ON
1
TX
RX
HB
COM N/C N/ O COM N/ C N/O COM N/ C N/O
0V 24V
I/P MON
A PBUS B
RE L1 / FIRE RE L2 / TROU B LE R E L3 / E A RTH
+ - + -
ZON E 1 ZON E 2
+ - + -
ZON E 1 ZO NE 2
+ - + -
ZON E 1 ZON E 2
+ - + -
ZON E 1 ZO N E 2
CLASS B ZONE MONITOR
ALL CIRCUITS A RE POWER LIMITED
ON
1
ON = PBUS MODULE
ON = CLASS A / OFF = CLASS B
ON = EA RTH MONITOR ACTIVE
ADDRESS
SETUP
ON
1
TX
RX
HB
COM N/C N/ O COM N/ C N/O COM N/ C N/O
0V 24V
I/P MON
A P BU S B
RE L1 / FIRE RE L2 / TROUB LE R EL3 / E A RTH
Refer to Axis
AX
Wiring Guide Section 9.
Note: Two (2) AX-CZM modules can be mounted in an AXM-009 enclosure.
4.18 AX-012 Panel Strip Printer
The AX-012 panel strip printer is an on-board thermal strip printer for use with the Axis
AX
fire alarm control panel.
The AX-012 can be configured to provide automatic or on demand printing of Axis
AX
fire alarm control panel history
event logs and system status events. In addition, when installed on an Axis
AX
networked system, automatic printing
of alarms and other events can be printed from anywhere on the network, unless the panel containing the strip
printer is programmed not to show the specific network event(s).
The AX-012 panel strip printer mounts in any available single aperture location on the Axis
AX
fire alarm control panel
inner door, although it’s normally installed on the left side of the second row (see figure 45).
Refer to AX-012 Panel Printer Installation Manual for detailed information regarding installation.
Figure 44
X-CZM AXM-009 Enclosure Mounting
Figure 45 - AX-012 Panel Printer
To Next Page
Loading...
Need help?
General