Advantech LNC M5800 Series

To Next Page

To Previous Page

Milling Machine Series

CNC operations

127

Advantech-LNC Technology Co., Ltd.

1.8.7 System update

 Due to safety concerns, the emergency stop 〔EMG-STOP〕 button on the controller's OP panel must be pressed

for the machine to be in "Not ready" state before system update can be executed.

 After pressing the <MAINTE> key on the controller's MDI panel, the 【System update】 key on the controller's

human machine page can be pressed to enter the system update page.

Advantech LNC M5800 Series - System Update