Milling Machine Series
CNC operations
72
Advantech-LNC Technology Co., Ltd.
1.6 Diagnosis group (DGNOS)
1.6.1 Alerts and warnings
Description of alert/warning functions:
In case of a problem, abnormality, and error during system operation, or the wrong G-CODE was used during
program editing, an alert will be issued and system operation will be suspended immediately. A small window
containing an alert/warning message will appear from any given page. After the alert/warning has been resolved,
the <Reset> key must be pressed to clear the alert/warning.
Instructions for alerts/warnings:
Alert page: After using the <DGNOS> key on the MDI panel to switch to diagnosis group, the 【Alert】 key or the
<ALARM> key on the MDI panel can be pressed to access this page.
To Next Page
Loading...