Milling Machine Series
CNC operations
147
Advantech-LNC Technology Co., Ltd.
All T codes calling this maker
macro
The editing method for here is identical to the program editing method for machining programs (please refer to
Opening and editing a file). Please pay attention to the special regulations for macro programming, where
"M99" must be added to the end of the program as shown in the figure below.
If the name of a new macro file is MAKER_MACRO_G123, it can be called by a program command containing the
command G123. When the program is executed to G123, contents of the MAKER_MACRO_G123 program will be
executed.
To Next Page
Loading...
Need help?
General
