GPIB OPERATION
3-2-12
RFLV?
Prepares message containing information on RF Level setting
in the following format:
:RFLV:UNITS <unit>;TYPE <type>;VALUE <nr2>;INC <nr2>;<status>
where: <unit> is character program data defining the default
RF level units (DBM, DBV, DBMV, DBUV, V, MV
or UV), <type> is character program data indicating
EMF or PD and <status> is a program mnemonic
indicating whether the RF output is ON or OFF.
Examples:
:RFLV:UNITS DBM;VALUE -103.5;INC 2.0;ON
:RFLV:UNITS DBV;TYPE EMF;VALUE -83.2;INC 0.5;ON
RFLV:OFFS?
Prepares message containing information on RF Level offsets
in the following format:
:CFRQ:VALUE <nr2>;:RFLV:OFFS:VALUE <nr2>;<status>;<activity>
where: <status> is a program mnemonic indicating whethe
the RF offset is ON or OFF and <activity> is a
program mnemonic indicating whether the offset
mode is enabled or disabled.
Example:
:CFRQ:VALUE 500000000.0;:RFLV:OFFS:VALUE -0.4;ON;ENABLE
RFLV
:HYST
[not used alone]
:ENABLE Enable Extended Hysteresis mode
:DISABLE Disable Extended Hysteresis mode
Data type :
None
Allowed suffices : None
Default suffix : None
:RFLV:HYST? Responds with status as follows:
:RFLV:HYST:ENABLE
or :RFLV:HYST:DISABLE
RFLV
:LIMIT
Set RF output level limit (short form)
:VALUE Set RF output level limit
Data type :
Decimal Numeric Program Data
Allowed suffices : Any one of DBM, DBV, DBMV, DBUV, V, MV or UV
Default suffix : dBm unless changed by UNITS command (see above).
:ENABLE Enable RF output level limit
:DISABLE Disable RF output level limit
:SAVE Save RF output level limit to memory
Data type :
None
Allowed suffices : None
Default suffix : None
To Next Page
Loading...
Need help?
General
