66 Firmware Version 7.2
TerraStar Settings
Press: Home button > GPS button > Serial (from Receiver drop-down box) > Receiver Setup (wrench)
button > General tab > TerraStar (from Differential Correction drop-down box) > Differential Source
Setup (wrench) button
• Serial Number
This box shows the serial number of
your receiver - used to purchase
TerraStar subscription.
• Automatic Tuning check box
Receiver will automatically select the
strongest frequency. Frequency drop-
down box will be grayed out when this
is selected.
• Frequency
In the Frequency drop-down list box,
select the geographic region where you
are located.
• Convergence Threshold
The receiver uses the standard
deviation of the solution to determine when the TerraStar position has converged. The receiver will label the
TerraStar solution as “converged” when the horizontal standard deviation reaches the Convergence
Threshold setting. Relaxing the convergence threshold shortens the time before a TerraStar solution is
reported as converged. However, it does not alter the absolute behavior of the solution.
Note: The use of TerraStar® differential requires purchase of a subscription from your Ag Leader dealer.
Settings related to using satellite differential correction vary based upon your geographic location. Setup
details are explained on the following pages. More specific information can be obtained through you Ag Leader
dealer.
Note: You will need to know serial number when contacting Ag Leader to set up the receiver.
Note: The display does not come with custom frequency numbers.
Differential Source
Terr aSta r
Differential Source
Terr aSta r- L
Serial Number
BFN14200204
Differential Source
TerraStar-D
Provider Settings
Automatic Tuning
Frequency
98W
30 in.
TerraStar Setup
Convergence
Threshold
To Next Page
Loading...
