10 7713395 R2
2.5. Gas Leak Hazards
If You Smell Gas:
• Turn off gas at the source if possible.
• Do not try to light or relight any appliance.
• Extinguish any flames and remove any sources of ignition from the vicinity of the bin.
• Do not touch any electrical switch.
• Evacuate all personnel from the vicinity of the source of the smell.
• Immediately call your gas supplier. Follow the gas supplier’s instructions.
• If you cannot reach your gas supplier, call the fire department.
2.6. Guards Safety
• Keep guards in place. Do not operate with guard removed.
• Do not walk on, step on, or damage guards.
• Lock out power before removing a guard.
• Ensure all guards are replaced after performing maintenance.
2.7. Work Area Safety
• Have another trained person nearby who can shut down the grain dryer in case of accident.
• The work area should be kept clear of bystanders, including children.
• Keep the work area clean and free of debris.
2.8. Drives and Lockout/Tagout Safety
Inspect the power source(s) before using and know how to shut down in an emergency.
Whenever you service or adjust your equipment, make sure you shut down your power
source and gas supply and follow lockout and tagout procedures to prevent inadvertent
start-up and hazardous energy release. Know the procedure(s) that applies to your
equipment from the following power sources.
For example:
• De-energize, block, and dissipate all sources of hazardous energy.
• Lock out and tag out all forms of hazardous energy.
• Ensure that only 1 key exists for each assigned lock, and that you are the only one that holds that key.
• After verifying all energy sources are de-energized, service or maintenance may be performed.
• Ensure that all personnel are clear before turning on power to equipment.
For more information on occupational safety practices, contact your local health and safety organization.
2. SAFETY CONTINUOUS MIXED-FLOW GRAIN DRYER WITH COMMANDER CONTROL SYSTEM
To Next Page
Loading...