7713395 R2 11
2.8.1 Electric Motor Safety
Power Source
• Electric motors and controls shall be installed and serviced by
a qualified electrician and must meet all local codes and
standards.
• Do not modify the magnetic starter. This component provides
overload and under-voltage protection.
• Motor starting controls must be located so that the operator
has full view of the entire operation.
• Locate main power disconnect switch within reach from
ground level to permit ready access in case of an emergency.
• Motor must be grounded.
• Guards must be in place and secure at all times.
• Ensure electrical wiring and cords remain in good condition;
replace if necessary.
S E R V I C E D I S C O N N E C T
ON
OFF
Lockout
• The main power disconnect switch should be in the locked position during shutdown or
whenever maintenance is performed.
• In the event of unexpected fan shutdown, the fan can be reset using the main power switch
located on the fan or using a reset button when equipped.
2.9. Personal Protective Equipment
The following Personal Protective Equipment (PPE) should be worn when installing the equipment.
Safety Glasses
• Wear safety glasses at all times to protect eyes from debris.
Coveralls
• Wear coveralls to protect skin.
Hard Hat
• Wear a hard hat to help protect your head.
Steel-Toe Boots
• Wear steel-toe boots to protect feet from falling debris.
CONTINUOUS MIXED-FLOW GRAIN DRYER WITH COMMANDER CONTROL SYSTEM 2. SAFETY
To Next Page
Loading...