114 7713395 R2
5.5. Lubrication
On greaseable sealed bearings, apply grease ONLY until a thin bead of new grease is visible along the seal edge.
Applying excessive grease may force out the seals, causing contamination and rapid bearing wear.
Table 7. Lubrication Data
PART DESCRIPTION LUBRICATION PRODUCT PER TIME PERIOD OF USAGE
Blower Drive Motor
Mfg Recommendation Mfg Recommendation
Cross Auger Gearbox
80/90 Gear Oil 1/2 Full
Check Weekly
Fan Shaft Bearings Mfg Recommendation
80 Hours
Cross Auger Bearings Mfg Recommendation
100 Hours
Roller Chains Le 451/452 Almasol
Annually
5.6. Motors
The OEM drive motors can vary in size and manufacturer, depending on the dryer size and usage requirements.
In order to properly maintain the various drive motors within your system, record the manufacturer, model
number, etc. from the motors ID tag. Follow manufacturers instructions for proper maintenance, including
possible lubrication of shaft bearings.
5. MAINTENANCE CONTINUOUS MIXED-FLOW GRAIN DRYER WITH COMMANDER CONTROL SYSTEM
To Next Page
Loading...