60 7713395 R2
4. Operation
Before continuing, ensure you have completely read and understood this manual’s
Safety section, in addition to the safety information in the section(s) below.
4.1. Operation Safety
• Keep away from rotating and moving parts, including the auger/mixer flighting, drive
components, shafts, and bearings.
• Lock the grain dryer access points (where equipped) and close all other access doors when
not in use.
• Always operate with guards, covers, and shields in place.
• Ensure maintenance has been performed and is up to date.
• Ensure that electrical cords are in good condition; replace if necessary.
• The area around the heater should be kept clear and free from combustible materials and
other flammable liquids.
• When heater is not in use, shut off gas valve on heater and at gas source.
• Have another trained person nearby who can shut down any powered loading, unloading, or
internal equipment in case of accident.
• Keep the work area clean and free of debris.
4.2. Equipment Pre-Check
After completion of assembly and before each use, inspection of the dryer is mandatory. The dryer should be
frequently checked and serviced for a trouble-free operation. Use the checklists shown in Figure 70 and Figure
71.
4. OPERATION CONTINUOUS MIXED-FLOW GRAIN DRYER WITH COMMANDER CONTROL SYSTEM
To Next Page
Loading...