8 7713395 R2
2. Safety
2.1. Safety Alert Symbol and Signal Words
This safety alert symbol indicates important safety messages in this manual. When you see
this symbol, be alert to the possibility of injury or death, carefully read the message that
follows, and inform others.
Signal Words: Note the use of the signal words DANGER, WARNING, CAUTION, and NOTICE with the safety
messages. The appropriate signal word for each message has been selected using the definitions below as a
guideline.
Indicates an imminently hazardous situation that, if not avoided, will result in serious injury or
death.
Indicates a hazardous situation that, if not avoided, could result in serious injury or death.
Indicates a hazardous situation that, if not avoided, may result in minor or moderate injury.
Indicates a potentially hazardous situation that, if not avoided, may result in property damage.
2.2. General Safety Information
Read and understand all safety instructions, safety decals, and manuals and follow them.
• Owners must give instructions and review the information initially and annually with
all personnel. Untrained users/operators expose themselves and bystanders to
possible serious injury or death.
• Use for intended purposes only.
• Do not modify the grain dryer in any way without written permission from the manufacturer. Unauthorized
modification may impair the function and/or safety. Any unauthorized modification will void the warranty.
• Follow a health and safety program for your worksite. Contact your local occupational health and safety
organization for information.
• Always follow applicable local codes and regulations.
2.3. Overhead Power Lines
• Keep grain dryers a horizontal distance of at least 100 ft (30.5
m) from power lines.
• Do not use the grain dryer if there is a chance of any loading
or unloading equipment contacting power lines.
• Do not locate grain dryers on both sides of a power line.
• Electrocution can occur without direct contact.
2. SAFETY CONTINUOUS MIXED-FLOW GRAIN DRYER WITH COMMANDER CONTROL SYSTEM
To Next Page
Loading...