42 7713395 R2
Wet Bin Empty and Dry Bin Full Switches (optional)
Note
These OPTIONAL switches are provided and installed by the customer.
• The Dry Bin Full switch should be placed near the top of the dry holding bin.
• The Wet Bin Empty switch should be placed near the bottom of the wet holding bin.
• The wires route to the main control box terminal strip and connects shown below:
Figure 40. Wet Bin Empty and Dry Bin Full sensor connections
DRY BIN
FULL
WET BIN
EMPTY
3.8. Discharge Equipment
Overview
The discharge system is offered using either auger or drag.
• The grain is fed into a discharge system by a pair of metering rolls powered by a DC drive motor and
controlled to discharge grain at the target moisture content.
3. FEATURES CONTINUOUS MIXED-FLOW GRAIN DRYER WITH COMMANDER CONTROL SYSTEM
To Next Page
Loading...