7713395 R2 7
Figure 4. Electrical Schematic Drawing
N CO CLAIMS P ROPRIETARY RIGHTS IN THE INFORMAT ON
D SCLOSED ON THIS DRAWING. T IS SSUED N
C NF IDENCE FOR ENGINEERING N FORMATION ONLY AND
MAY NOT BE REPRODUCED OR USE D TO MANUFACTURE
A YTHING SHOWN HERE ON WTHOU T DIRECT WR TTEN
P RMISSION FROM NECO TO THE USE R.
NOTE: The dryer electrical schematic
drawing is located on the inside of the
control panel door.
REVISION
NUMBER
DRAWING
NUMBER
To register your grain dryer, scan the following QR code, or call AGI NECO at 402-453-6912. For SureTrack Dryer
Manager registration, see the instructions included with the SureTrack gateway or call 855-835-5231.
1.2. Intended Use
The grain dryer is intended for use as listed below and described throughout this manual. Use in any other way
is considered contrary to the intended use and is not covered by the warranty.
Intended use for the grain dryer:
• Designed to dry free-flowing grains, field crops and oil seeds.
1.2.1 Misuse
Do not install/use the grain dryer for/with:
• drying grains at temperatures higher than recommended.
• applications other than drying farm crops.
• excessive chaff, seed pods, half cobs, leafy materials, and other foreign material.
• finely milled grain dust.
• bypassed safety sensors.
CONTINUOUS MIXED-FLOW GRAIN DRYER WITH COMMANDER CONTROL SYSTEM 1. INTRODUCTION
To Next Page
Loading...