7713395 R2 149
8.12. Commander Wi-Fi access (Vijeo Air App)
Version date: 7/5/2018
Warning
• You must consider the potential of accidental touches from remote mobile devices. Know and understand
the hazards regarding equipment movement started by a remote operation. You, as the operator, are
responsible for all gates and interlock for protecting people and equipment.
• Failure to follow these instructions can result in death, serious injury, or equipment damage.
Required Hardware (source locally)
• Wi-Fi router
• Ethernet cable
• Tablet or cell phone with Wi-Fi capability
Hardware installation
• Locate Wi-Fi router in a suitable location near the HMI enclosure.
• The Wi-Fi router should be powered by its own power supply.
• Connect an ethernet cable from Wi-Fi router to the ethernet switch inside the HMI enclosure.
Router configuration
• Configure router
– static IP address 10.10.11.5
– subnet mask 255.255.255.0
– gateway 10.10.11.211
• Set router name (NECO dryer)
• Set router security password to prevent unauthorized access
• Record security password here ____________________
Required Software (download app)
• Schneider Vijeo Design’Air (available on google apps)
Tablet / Phone Wi-Fi settings
• Connect to router (NECO dryer)
• Enter router security password
Initial Vijeo Design’Air app settings
1. Press “+ Add device” icon
2. Name: NECO dryer
3. Host: 10.10.11.101
4. Port: 37891
5. Press “OK”
Using the Vijeo Air app
CONTINUOUS MIXED-FLOW GRAIN DRYER WITH COMMANDER CONTROL SYSTEM 8. APPENDIX
To Next Page