118 7713395 R2
Problem Check Cause Solution
Check Fill rotary switch
operation
PLC thinks that dryer is full
Repair/replace faulty rotary
switch
MAIN MENU-> ALARMS Alarm Present
Address any alarm problem in
RED
Unable to get Dry Transport
motors to start
MAIN MENU-> SET-UP-> FILL
& EMPTY SETUP
DRY BIN FULL SWITCH
enabled
Dry bin is full
Presence of active alarm DISCHARGE PLUGGED
Clear plugged discharge and
reset alarm
6. TROUBLESHOOTING CONTINUOUS MIXED-FLOW GRAIN DRYER WITH COMMANDER CONTROL SYSTEM
To Next Page
Loading...