Programming 1
Advanced Operation Manual 13
• Detector gas flow (on/off), including NPD H
2
fuel gas
• Inlet septum purge flow
Programming run time events
1 Press [Run Table].
2 Press [Mode/Type] to see the available run time events.
3 Scroll to the event to be programmed. Press [Enter].
4 Enter values for the Time: and the other parameter. Press
[Enter] after each entry.
5 Press [Mode/Type] to add another event. Press [Status] to
terminate entries.
The run table
The programmed events are arranged in order of execution
time in the Run Table. This is a brief example:
RUN TABLE (1 of 3) Event 1 rotates a valve.
Time: 0.10
Valve #2 On
RUN TABLE (2 of 3) Event 2 adjusts the signal
Time: 3 range.
Analog signal 2 range 2
RUN TABLE (3 of 3) Event 3 resets Valve #2 to its
Time: 4.20 original position in preparation
Valve #2 Off for another run. Valves do not
reset automatically.
Adding events to the run table
1 To add new events to the run table, press [Mode/Type]
while on the Time: line of any entry.
2 Select the event type.
3 Set appropriate Time: and other parameters. Some require
numbers; others require [On/Yes] or [Off/No].
4 Repeat until all entries are added. Events are
automatically placed in order by execution time.
To Next Page
Loading...
Need help?
General
