Programming 1
Advanced Operation Manual 15
Clock Time Programming
Clock time programming allows certain setpoints to change
automatically at a specified time during a 24- hour day. Thus,
an event programmed to occur at 14:35 hours will occur at
2:35 in the afternoon. A running analysis or sequence has
precedence over any clock table events occurring during this
time. Such events are not executed.
Possible clock time events include:
• Valve control
• Method and sequence loading
• Starting sequences
• Initiating blank and prep runs
• Column compensation changes
• Adjustments of the detector offset
Using clock time events
The Clock Table function allows you to program events to
occur during a day based on the 24- hour clock. Clock table
events that would occur during a run or sequence are
ignored.
For example, the clock table could be used to make a blank
run before you even get to work in the morning.
Programming clock time events
1 Press [Clock Table].
2 Press [Mode/Type] to see the available clock time events.
3 Scroll to the parameter to be programmed.
4 Edit Time: and the setpoints for this event.
5 Press [Mode/Type] to add another event. Press [Status] to
terminate entries.
When the clock event is executed, a confirming message
appears.
To Next Page
Loading...
