216 Advanced Operation Manual
6 Valves
Valve temperature programming
Most valve applications are isothermal; however, you can
define three temperature ramps if desired. Press [Aux Temp
#], then [1] or [2]. Program this ramp the same as an oven
ramp. Refer to “Setting the oven parameters for ramped
temperature” on page 152 for more information.
Configuring an Aux thermal zone
To configure a thermal Aux zone (1 or 2), press [Config][Aux
Temp #], then [1] or [2]. Press [Mode/Type], then select the
type of device to be controlled. Press [Enter].
To Next Page
Loading...
