Agilent Technologies 7890 Series - Adding Events to the Clock Table; Deleting Clock Time Events; Editing Clock Time Events

16 Advanced Operation Manual
1 Programming
Adding events to the clock table
1 Press [Clock Table].
2 Press [Mode/Type]. When entries are added, they are
automatically ordered chronologically.
3 Select the event type.
4 Set appropriate parameters.
5 Repeat this process until all entries are added.
Editing clock time events
1 Press [Clock Table] to view all events programmed.
2 Scroll to the event you want to change.
3 To edit the time for an event, move the cursor to the line
labelled Time: and type the desired time.
4 To edit a setpoint value, scroll to the setpoint item. Press
[On/Yes] or [Off/No], or enter a numerical value for the
setpoint.
Deleting clock time events
1 Press [Clock Table].
2 Use [Delete] to remove events from the clock time table.
You will be asked to confirm the deletion.
3 Press [On/Yes] to delete the current timed event; press
[Off/No] to cancel this operation.
To delete the entire table, press [Delete][Clock Table].