Agilent Technologies E5071C ENA - Required Tools

Chapter 6 165
Replacement Procedure
Required Tools
6. Replacement Procedure
Required Tools
The following tools are required for repair of E5071C.
Table 6-1 Required Tools
Assembly TORX screwdriver flat edge
screwdriver
torque
screwdriver
TORX T10
cutting
plier
hex key open torque wrench open
torque
driver
set
*1
T8 T10 T15 T20 1.5 mm 9/16 in. 5/8 in. 5/16 in.
Outer Cover √ √ √
Front Panel √ √ √ √
Removable Hard Disk
Assembly Removal
√ √ √ √
Removable Hard Disk
Drive Replacement
√ √
Removable Hard Disk
Assembly Removal
Opt.017
√ √ √
√
Removable Hard Disk
Drive Replacement
Opt.017
√ √
Hard Disk Assembly
Removal Opt.019
√ √ √ √
Hard Disk Drive
Replacement Opt.019
√ √
Power Supply √ √ √ √
Digital Bridge √ √ √
Handler I/O √ √ √
USB (USBTMC)
Interface Card
√ √ √
PCI DSP Card and
GPIB Card
√ √ √ √
Digital Motherboard √ √ √
Analog Base Module √ √ √ √
Level Vernier Module √ √ √ √ √ √
Synthesizer Module √ √ √ √ √ √
Receiver Module √ √ √ √ √ √ √
Switch √ √ √ √ √ √ √
Fan √ √ √ √ √ √
PCA DC Bias Board √ √ √ √
Crystal Oven Board √ √ √
Analog Motherboard √ √ √ √ √ √ √
Front Panel √ √ √ √
Control Touch Panel √ √ √ √
Inverter √ √ √ √ √
LCD √ √ √ √