Chapter 6 175
Replacement Procedure
Removable Hard Disk Assembly Removal (Option 017)
6. Replacement Procedure
Removable Hard Disk Assembly Removal (Option 017)
Tools Required
• TORX screwdriver, T10, T15, and T20
• Flat edge screwdriver
Removal Procedure
Refer to Figure 6-6 for this procedure.
Step 1. Remove the outer cover as described in “Outer Cover Removal” on page 167.
Step 2. Remove the front panel as described in “Front Panel Removal” on page 168.
Step 3. Disconnect the two cables (item 1).
Step 4. Remove the three TORX T10 screws (item 2) fastening the removable hard disk assembly.
Step 5. Be careful to release the hook from chassis (item3) and lift the removable hard disk
assembly.
Step 6. Remove the four TORX T10 screws (item 4) fastening the bracket.
To Next Page
Loading...
Need help?
General