256 Appendix B
System Recovery
System Recovery
System Recovery
By executing system recovery, you can return the system of the E5071C (the Windows
operating system) to the factory state (at the time of purchase
*1
).
NOTE System recovery is a function of Windows and not a function of the E5071C Firmware.
The system recovery procedure is different in accordance with the HDD revision. The
HDD revision can be checked using the following procedure:
Step 1. In E5071C, from Windows Start Menu, click on My Computer.
Step 2. The volume label for C: drive is displayed in Hard Disc Drive area.
CAUTION Strictly follow the steps described below. If you do any operation other than the following
steps, the system may not be recovered.
Types of system recoveries
The following 2 types of system recoveries are available.
o Factory recovery
Returns the contents of the C drive to the factory state.
o User recovery (available only when HDD revision is CN924 or below)
Returns the contents of the C and D drives to a user-specified state. To use this
function, you must prepare for recovery in advance. For information on the
preparation, see
“Procedure to execute the factory recovery (HDD Revision: CN924 or
below)” on page 260 for information on the execution, see “Procedure to execute the
factory recovery (HDD Revision: CN924 or below)” on page 260.
*1.If the hard disk failed and has been replaced after purchase, the state when the replacement
was performed is recovered.
To Next Page
Loading...
Need help?
General