Chapter 7 251
Post-Repair Procedures
Post-Repair Procedures
7. Post-Repair Procedures
PCA Front
Key (A52)
No adjustment needed Perform “To Execute the diagnostics Test” on
page 69
Perform “To Check the Front Panel” on page 82
Handler I/O
Board (A25)
No adjustment needed Perform “To Execute the diagnostics Test” on
page 69
GPIB Board
No adjustment needed Perform “To Check the GPIB” on page 84
USB Interface
Card
No adjustment needed Perform “To Check the USB Interface Card” on
page 84
PCA Digital
Board (A53)
No adjustment needed Inspect the Booting Process
Perform “To Execute the diagnostics Test” on
page 69
Perform “To Check the Video Output” on page
84
Removable
Hard Disk
Drive
Calibration of the Touch Screen. Inspect the Booting Process
Power Supply
Assembly
No adjustment needed Inspect the Booting Process
LCD TPANEL
Assembly
Calibration of the Touch Screen Inspect the Booting Process
Perform “To Execute the diagnostics Test” on
page 69
Perform “To Check the LCD” on page 83
Table 7-3 Post-Repair Procedures for Digital Assemblies
Replaced
Assembly or
Part
Required Adjustments
Correction Constants (CC)
Verification
To Next Page
Loading...