Agilent Technologies N9310A User Manual

106 N9310A User’s Guide
6 Subsystem Command Reference
RF Start
:FREQuency:RF:STARt <val> <unit>
:FREQuency:RF:STARt?
This command sets the start frequency in an RF sweep. The
start frequency should always be lower than stop frequency
in an RF sweep.
The query returns the current start frequency.
RF Stop
:FREQuency:RF:STOP <val> <unit>
:FREQuency:RF:STOP?
This command sets the stop frequency in an RF sweep. The
stop frequency should always be set higher than the start
frequency.
The query returns the current stop frequency.
Range 9 kHz to 3 GHz
Valid unit GHz, MHz, kHz
Minimum increment 0.1 Hz
*RST value 9.0000 kHz
Returned data format <val> <unit>
Front panel access Sweep > Step Sweep > RF Start
Range 9 kHz to 3 GHz
Valid unit GHz, MHz, kHz
Minimum increment 0.1 Hz
*RST value 3.000 000 0000 GHz
Returned data format <val> <unit>
Front panel access Sweep > Step Sweep > RF Stop

Agilent Technologies N9310A Specifications

General

Brand	Agilent Technologies
Model	N9310A
Category	Test Equipment
Language	English