Key Reference 4
N9310A User’s Guide 69
Switch
Pressing this front panel switch toggles power to the signal
generator between on (green LED on) and standby (orange
LED on). In standby mode, the signal generator is switched
off, but the instrument is still connected to the line power.
The rear panel line switch and the detachable power cord is
the instrument disconnecting device. The front panel power
switch, therefore, is not, and should not be used as a power
switch.
Remote
Standby
On
N9310A RF Signal Generator 9 kHz – 3.0 GHz
Standby
Switch
LIN E:
100-240V
50- 60Hz
55W MAX
Power
Switch
CAUTION
Avoid turning off power to the signal generator when current state is
changing as a result of front panel operation or remote control.
To Next Page
Loading...
Need help?
General
