Agilent Technologies N9310A User Manual

70 N9310A User’s Guide
4Key Reference
Preset
Pressing hardkey sets the signal generator to a factory
default state. Pressing this hardkey does not clear the
customized configuration files.
Factory Default Settings
Item Default Item Default
Frequency 3.000 000 0000 GHz Sweep Scale Linear
Amplitude –127.0 dBm Sweep/Point Trigger Immediate
LF Out Off Sweep Direction Up
LF Out Freq 1.0000 kHz Trig In Polarity Negative
LF Out Ampl 500 mV Modulation
Mod ON/OFF On Modulation State Off
RF ON/OFF Off AM Depth 0.0 %
Sweep FM Deviation 0.000 rad
Sweep Mode Off FM Deviation 20 Hz
RF Start 9.0000 kHz Pulse Period 200 μs
RF Stop 3.000 000 0000 GHz Pulse Width 100 μs
Amplitude Start –127.0 dBm Modulation Source INT
Amplitude Stop –126.0 dBm Modulation Rate 1.0000 kHz
LF Start 20.0 Hz Ext Coupling AC
LF Stop 80.0000 kHz System
#Point 10 File Catalog Local
Step Dwell 10.0 ms Opt. F Noise Normal
Sweep Repeat Cont Reference Source Int_10 MHz
Preset

Agilent Technologies N9310A Specifications

General

Brand	Agilent Technologies
Model	N9310A
Category	Test Equipment
Language	English