Agilent Technologies N9310A

Instrument Messages 7
N9310A User’s Guide 165
Command Errors
The messages listed below are command errors, which are
saved into local registers. Press > Error Info to read or
delete them.
-100 Command error;
An unrecognized command or data type was encountered.
This message is used when the device cannot detect more
specifics described for errors - 101 to - 109.
-101 Invalid character;
A syntactic element contains an invalid character.
-102 Syntax error;
An unrecognized command or data type was encountered.
-103 Invalid separator;
The parser recognized a separator that is not allowed.
-108 Parameter not allowed;
More parameters were received than expected for the
header.
-109 Missing parameter;
Fewer parameters were received than required for the
header.
-110 Command header error;
An error was detected in the header. This message is used
when the device cannot detect more specifics described for
errors - 111 to - 119.
Utility