16 N9310A User’s Guide
2 Getting Started
Safety Notice
Please read the following warnings and cautions carefully
before you power on the signal generator to ensure your
personal and instrumental safety.
WARNING
Always use a well-grounded, three-pin AC plug and power cord to
connect to a power source. Personal injury may occur if there is any
interruption of the AC power cord of the signal generator. Intentional
interruption is prohibited.
WARNING
Personal injury may result if the signal generator covers are removed.
There are no operator service parts inside. To avoid electrical shock,
refer servicing to qualified personnel.
WARNING
Electrical shock may result if the signal generator is connected with
the power supply when cleaning. Do not attempt to clean internally.
CAUTION
Installing the signal generator in other racks may promote shock
hazards, overheating, dusting contamination, and inferior system
performance. Consult to your Agilent customer engineer about
installation, warranty, and support details.
CAUTION
Damage to the signal generator may result when the total power
dissipated in the cabinet is greater the 800 watts. When this condition
exists, forced convection must be applied.
CAUTION
Avoid turning off the signal generator when current state is changing
as a result of front panel operation or remote control.
To Next Page
Loading...
Need help?
General
