Agilent Technologies N9310A User Manual

168 N9310A User’s Guide
7 Instrument Messages
Execution Conflict
The system messages listed below are execution conflicts,
indicating settings conflict during your operation. These
messages will be cleared from the screen by the signal
generator automatically 30 seconds later since they were
generated.
-221 Setting conflict;
start frequency must be smaller than stop frequency.
-221 Setting conflict;
start amplitude must be smaller than stop amplitude.
-221 Setting conflict;
AM cannot be enabled with I/Q or pulse.
-221 Setting conflict;
FM cannot be enabled together with ΦM.
-221 Setting conflict;
LF cannot be enabled together with AM/FM/ΦM/LF sweep.
-221 Setting conflict;
Pulse width must be narrower than pulse period.
-221 Setting conflict;
ΦM deviation range is decided by ΦM rate.
-221 Setting conflict;
AM carrier frequency cannot be lower than 100 kHz.
-221 Setting conflict;
Modulation rate must be lower than carrier frequency.
-222 Value clipped to upper limit.
-222 Value clipped to lower limit.
-255 Media/Directory full.

Agilent Technologies N9310A Specifications

General

Brand	Agilent Technologies
Model	N9310A
Category	Test Equipment
Language	English