122 N9310A User’s Guide
6 Subsystem Command Reference
AM Subsystem
The AM subsystem controls the settings and parameters
associated with amplitude modulated signal.
AM State
:AM:STATe ON|OFF|1|0
:AM:STATe?
This command toggles the AM state between ON and OFF.
However, applying an amplitude modulation to the RF
carrier requires you also set MOD on.
See “Modulation State Subsystem” on page 137.
The query returns the current AM state.
Range ON(1), OFF(0)
*RST value OFF
Returned data 1, 0
Front panel access AM > AM On/Off
To Next Page
Loading...
