Subsystem Command Reference 6
N9310A User’s Guide 111
Trigger Subsystem
The trigger subsystem controls the settings and parameters
associated with triggering a sweep.
Immediate Trigger
:TRIGger:IMMediate
This command has no effect unless sweep is armed. It has
an equivalent function to the
hardkey in activating an
armed sweep.
There is no query for this command.
Front panel access:
Single Sweep
:TRIGger:SSWP
This command initiates a single RF/LF/Amplitude sweep
when the following conditions are met:
• Sweep trigger and point trigger are both set to
IMMediate
• Sweep repeat is set to SINGle
• An RF/LF/Amplitude sweep is enabled and first free run
of the sweep is complete
There is no query for this command.
Front panel access:
Trigger
Trigger
Enter
To Next Page
Loading...
