Key Reference 4
N9310A User’s Guide 73
Sweep
Pressing reveals a menu of softkeys. Use these softkeys
to define a series of points containing frequency, amplitude,
and dwell time information for step sweep.
Sweep
Off
Sweep State
LF
Ampl
Step Scaling
LOG/LIN
Sweep Type
Step/List
Sweep Repeat
Single/Cont
Step Sweep
RF Stop
RF Start
# Point
LF Start
LF Stop
RF
AM
Enters sweep state submenu:
Disables a sweep
Enables low frequency sweep mode
Enables amplitude sweep mode
Enables radio frequency sweep mode
Continued
Toggles step scale between logarithm and linear
Toggles sweep repeat between single and continuous
Enters step sweep configuration submenu:
Sets RF sweep start frequency
Sets RF sweep stop frequency
Sets LF sweep stop frequency
Sets sweep points
Sets LF sweep start frequency
Toggles sweep type between step and list
To Next Page
Loading...
