Programming Fundamentals 5
N9310A User’s Guide 87
Connecting the N9310A to a PC via the USB Port
No extra driver is required to connect the N9310A via the
USB port to a PC. All you need is the Agilent IO Libraries
Suite version 14.1 or later, and you can find this IO libraries
suite in the documentation CD in the shipment along with
your N9310A.
Refer to the following steps to finish the connection:
1 Install IO Libraries Suite
2 Switch on the N9310A
3 Connecting the signal generator to a PC with a USB cable
4 After a while, the PC finds your N9310A as a new
hardware and prompts a message saying “Found new
hardware...”. A Found New Hardware Wizard is initiated
immediately.
Connecting instrument
Connecting PC
To Next Page
Loading...
Need help?
General
