C315 Indoor Monitor Administraor Guide
Parameter Set-up:
•
HTTP Command: enable the HTTP command if you want the action to be
implemented on a designated third-party device
•
SIP Message: enable SIP message if you want the SIP message to be sent to a
designated SIP account as an action
•
Call: enable call if you want a call to go to a designated SIP or IP number.
15.3.7.2
Configure Alarm Action via HTTP Command
To set up the HTTP Command action, you can click Enable in the Send HTTP field to
enable the actions for the alarm sensor installed in different locations. Then enter the
HTTP command provided by the manufacturer of the device on which the action is to be
carried out. To set it up go to Arming > Alarm Action > HTTP Command Setting.
To Next Page
Loading...
Need help?
General
