C315 Indoor Monitor Administraor Guide
Note
•
The general configuration file for the in-batch provisioning is with the format cfg
taking R29 as an example r000000000029.cfg (10 zeros in total), while the MAC-
based configuration file for the specific device provisioning is with the format
MAC_Address of the device.cfg, for example, 0C110504AE5B.cfg.
•
DHCP Option 43: if the device does not get an URL from DHCP Option 66, it will
automatically use DHCP Option 43. This is done within the software and the user
does not need to specify this. To make it work, you need to configure the DHCP
server for option 43 with the updated server URL init.
18.5
Static Provisioning Configuration
You can manually set up a specific server URL for downloading the firmware or
configuration file on device web Upgrade > Advanced > Automatic Autop interface. If an
autop schedule is set up, the indoor monitor will perform the auto-provisioning at a
specific timing according to autop schedule you set up. In addition, TFTP, FTP, HTTP, and
HTTPS are the protocols that can be used for upgrading the device firmware and
configuration.
Parameter Set-up:
To Next Page
Loading...
Need help?
General
