C315 Indoor Monitor Administraor Guide
Note
•
When the NTP-based automatic date time is switched off then parameters
related to NTP server will become non-editable. And when it is switched on,
then time and date will be denied editing.
default time zone and the NTP server (Network Time Protocol). You can also set it up
manually by ticking the check box and then entering the time and date you want and
pressing the Save tab to save the setting.
•
Set Date: enter the date when it is in manual mode.
•
Set Time: enter the time when it is in manual mode.
•
Use 24-Hour Format: tick the checkbox to select 24-hour timeformat.
•
Time Zone: select the specific time zone depending on where the device is used. The
default time zone is GMT+0.00.
•
Date Format: select the date format as you like among the three format options. The
six formal options are Y-M-D, Y/M/D, D-M-Y, D/M/Y, M-D-Y, M/D/Y.
•
Time Format: select 12-hour or 24-hour time format as you like.
•
NTP Server: enter the NTP server you obtained in the NTP server field.
6.2.2
Time Setting on the Device Web Interface
Time setting on the web Phone > Time/Lang interface also allows you to set up the NTP
server address that you obtained to automatically synchronize your time and date. And
when your time zone is selected, the device will automatically notify the NTP server of its
time zone so that the NTP server can synchronize the time zone setting in your device.
To Next Page
Loading...
