C315 Indoor Monitor Administraor Guide
24.2
PCAP for Debugging
PCAP in Akuvox indoor monitor is used to capture the data package going in and out of the
devices for debugging and troubleshooting purpose. You can set up the PCAP on the
device web Upgrade > Advanced > PCAP interface properly before using it.
Parameter Set-up:
•
Specific Port: select the specific ports from 1-65535 so that only the data packet from the
specific port can be captured. You can leave the field blank bydefault.
•
PCAP: click Start tab and Stop tab to capture a certain range of data packets before
clicking Export tab to export the data packets to your Local PC.
•
PCAP Auto Refresh: select Enable or Disable to turn on or turn off the PCAP auto
fresh function. If you set it as Enable then the PCAP will continue to capture data
packets even after the data packets reached their 50M maximum in capacity. If you
set it as Disable the PCAP will stop data packet capturing when the data packet
captured reaches the maximum capturing capacity of 1MB.
24.3
User Agent
User agent is used for identification purpose when you are analyzing the SIP data packet.
To do this configuration on web Account > Advanced interface.
To Next Page
Loading...
Need help?
General
