C315 Indoor Monitor Administraor Guide
10.2
Device Deployment in Network
Akuvox C315 series indoor monitor should be deployed before it can be properly
configured in the network environment in terms of their location, operation mode, address
and extension numbers as opposed to other devices for device control and the
convenience of the management. To deploy the device in the network on web Network >
Advanced > Connect Setting interface.
Parameter Set-up:
•
Connect Mode: it is automatically set up according to the actual device connection
with a specific server in the network such as SDMC or Cloud and None. None is the
default factory setting indicating the device is not in any server type, therefore you
are allowed to choose Cloud, SDMC in discovery mode.
•
Discovery Mode: turn on the discovery mode of the device so that it can be
discovered by other devices in the network, and disable itif you want to conceal
the device so as not to be discovered by other devices.
•
Device Node: specify the device address by entering device location info from the
left to the right: Community, Unit, Stair, Floor, Room insequence.
•
Device Extension: enter the device extension number for the device you installed.
•
Device Location: enter the location in which the device is installed and used.
10.3
Device NAT Setting
NAT (Network Address Translation) allows hosts in an organization's private intranet to
transparently connect to hosts in the public domain.
There is no need for internal hosts to have registered Internet addresses. It is a way to
translate the internal private network IP address into a legal network IP address
To Next Page
Loading...
Need help?
General
